This unique mount lets you mount your pull bar to the bottom of your chassis and this becomes your drive shaft loop all-in-one. Includes bolts, washers, nuts, and spacers.
HMS 4-Bar Chassis Plates (rear trailing arm mount) work with HMS 4-link and 3-link suspension cage set ups. Lower bars 13", 14", 15", and 16" long and upper bars 16", 17", and 18". 1/2" bolt holes.
All Speedway street stock roll cage kits are made from pre-bent 1-3/4" diameter .104 wall HREW 1020 mild steel tubing. Tubing is pre-notched where needed for easy assembly. Some notching is still required.
We have found that the tubing...
Steel weld bungs for 1" OD .063 and .083 wall tube for building upper a-frames with our Double Adjusters and 5/8" Suspension Tubes.
Body support tabs can be bent to your specific angle or fastened to an angle iron to give you adjustability on your body bracing.
These weld on tabs make mounting body bracing a breeze. While being lighter and cleaner looking than a gusset with a nut, these tabs have a threaded 1/4" hole in them allowing for hassle free mounting.