Kyle Strickler inspired adjustable shock mounts let you fine tune your cars dynamic attitude in ½” increments. Brackets sold as a kit with weld plates and hardware
Travis Sauter designed bump stop package adjuster. Adjust your bump stops to the thousandths of an inch!
These adjusters allow you to run your bump stop package outside your shocks for quick tuning. The shaft slips apart once the upper bolt is removed from chassis for fast adjustments to your bumps.
Butch Vandoorn inspired carbon fiber packers will outlast the metal packers on the market.
Clamp on steel shock mount allows you to mount a shock without welding and also allows adjustable height. Mount comes with shock swivel.
This tool is for adjusting the sweeps on your shock shaft. Screw on cover design so that you can put it in your pocket without poking your rocket.
Jimmy Mars inspired clevis style screw jacks are designed to use our shock bolts with the spacer machined on them and the opposite side spacer press fit into clevis so you no longer have to fumble spacers around. Screw jacks is 1 1/8" fine thread steel...
Don't trust the pin? These are a cross between a bolt and a shock pin using a nut like a bolt would. Spacer part is machined on like the pins, Thread is 1/2"-13 coarse. Bolts are available in steel or aluminum.
Shock mount extension bolts into your existing mount on your chassis lowering your spring table 2". Comes with shock bolt.
Aluminum and steel quick change shock pins
Available for Penske, Ohlins, JRI, ARS, AFCO, and Integra reservoirs. Our stationary design allows for fast removal and installation of your reservoir by simply tuning the quick knob. Mount swivels 360 degrees two ways for easy positioning. Bar sizes...
These are a Ryan Rosenow inspired aluminum washer to eliminate seal damage when you bottom out a shock. They have a countertbore to fit over the jam nut on the rod end side of the shock.