For use when the gear is out of the rear end to keep it clean.
Our axle tube lead clamp allows you to fasten lead to your rear axle tube to gain traction. Clamp is drilled and tapped 1/2"-13 on a 5" and 6" bolt center spacing.
Billet one piece quick change nuts pre-drilled for our quick lock kit or safety wire. Sold individually.
Small breather for your fuel cell or rearend. No need for line, attaches right to the fuel cell and has built in anti-slosh.
7/16" x 3/4" Aluminum bolts to use with your lightweight dust covers.
Changing and carrying Ford 9" gears have never been so easy. Handle bolts to pinion cover giving you the leverage and control you've always wanted.
Our gear changer is one sweet piece. When you need to change gears this is your drain pan for the lube, as well as a pump to re-install the lube in your rear end. You can use a drill or crank it by hand. Drill is NOT included, the hex and hand crank are...
Billet dust caps are 1/4" thick for superior strength. Manufactured with a square O-Ring so it stays put during installation.
Billet grand national hub socket with 1/2" drive.
No more safety wire! Change gears in a flash! Kit comes with two cover nuts, two locks, and two clips.
Our trick rear end drain pan makes the gear changers job a dream! It's wider to catch all the fluid, has a spot for each gear to drain, a spot to stand the rear cover up to drain, a spot for your rear cover nuts, and even your wrench. This trick pan has...
Used on the adjusting nuts for the Ford 9" gear setup